 | |
|
| 钎焊板式换热器特点： |
结构简单，易安装：使用板片厚度小、传热系数高，换热效率大于80%，滞液量少。
体积小、重量轻，节约运输成本：总量仅相当于管式换热器的20%-30%。
可承受高温高压：温度极限可达250℃,压力可达45bar。
节能、用水量少：在相同的工作情况下，用水量只需要相当于管壳式换热器的三分之一。
污垢系数低：湍流效果好，降低了污垢系数，从而减少清洗次数，节约维修成本。
不生锈、耐腐蚀：使用如316L、304等不锈钢的板片，可以降低腐蚀问题。
外形美观、性能高...
|
| The characteristics of bazed plate heat exchanger： |
Simple structure and easy to be installed: the thickness of the plate is small, the heat transfer coefficient is high, the heat transfer efficiency is more than 80%, and the stagnant fluid is less.
Small size, light weight, saving transportation cost: the total amount is equivalent to 20%-30% of the tube type heat exchanger .
To bear high temperature and high pressure: the temperature limit of up to 250 degrees Celsius, the pressure can reach 45bar.
Energy saving, low water consumption: in the same work situation, the water consumption is only equivalent to 1/3 of shell and tube type heat exchanger.
Low fouling coefficient: the turbulence effect is good to lower the dirt coefficient , and the cleaning times are reduced , and the maintenance cost is saved.
No rust, corrosion resistance: the use of such as 316L, 304 stainless steel plate, can reduce the corrosion problems.
Beautiful appearance, high performance...
|
| |
|
扫描加我微信
